
这让我有了一些相当不靠谱的想法……
当您通过我们网站上的链接购买时,我们可能会获得联盟佣金。运作方式如下。
正如我们所料,我们的澳大利亚硬件评测同行 TrashBench 又在玩花样了。不久前,他把显卡装在“错误”的位置却换来了更好的散热效果,如今他……可以说正在考虑更大的动作。他把一台旧的 4-kW 分体式空调外机(不含冷媒)拆下来,把它的散热器-风扇单元接到水冷回路上以评估其性能。
他在视频开头模仿了《鳄鱼邓迪》的经典桥段,然后着手对设备进行改造,因为他只需要散热器、风扇和水泵。大部分繁杂的内部零件都被移除,并加装了脚轮以便移动。随后,TrashBench 又在主外壳里加了一个普通的水箱。
转到 PC 端,他通过适度加热和用力把一个 T 形接头改成了 Y 形接头,并且凭借一贯的巧手,为各种冷头设计了 3D 打印安装支架。大约在这时,成功似乎已成定局——在 02:49 处你可以看到,他的指节向机器之神献上了必要的“血祭”。
启动整套系统后,他立即开始基准测试,同时请出了功耗更低的新款 RTX 5060 和发热更高的上一代 RTX 3080。RTX 5060 是一款非常节能的 GPU,默认散热器下温度仅 52°C。然而,四千瓦级散热能力的加持把温度压到了 33°C,大约相当于温水,降幅达 16°C。
有了如此充裕的散热余量,他决定对 GPU 进行极限超频,将 Boost 频率从 2902 MHz 提升到 3300 MHz。尽管频率提高了 14%,平均 FPS 仅提升 3%,清晰展示了自 RTX 2000 系列以来 Nvidia 在功耗/性能曲线上调校得多么到位。
疯狂的改装者把 360mm AIO 水冷散热器绑到笔记本上,温度降至 40°C 以下
改装者发现把 GPU 放在“错误位置”可将热点温度降低 19°C
爱好者用双塔 CPU 散热器改装 GTX 1080 Ti,温度最高下降 32°C
随后,他把目标转向 RTX 3080——这块功耗惊人、更具挑战性的显卡。结果依旧被轻松击败:温度从 65°C 降至 28°C,仅略高于室温。不过,对这块卡超频后 FPS 同样只提升 3%,几乎不值得他花时间。
最终挑战是看看这台小巧的 Fujitsu 单元能否同时应对 GPU 与 CPU 的双重负载。他手头选用的处理器可能是最难压住的民用芯片——速度飞快、炙手可热的 Intel Core i9 14900K。
在您的收件箱中直接获取 Tom’s Hardware 的最佳新闻与深度评测。
连接完成后,CPU 温度下降了 18°C,降至 76°C,对于这块不在液氮桶旁的芯片来说算是相当出色的成绩。至于显卡,其温度传感器几乎没有变化,表明这台散热器的潜力远超 TrashBench 的硬件需求。
在 Google News 上关注 Tom’s Hardware,或将我们添加到首选来源,以便在信息流中获取最新新闻、分析与评测。
Bruno Ferreira 是 Tom’s Hardware 的特约撰稿人。他在 PC 硬件和相关配件方面拥有数十年经验,同时也是一名开发者。他痴迷细节,喜欢在自己热爱的话题上长篇大论。不写作时,他通常会玩游戏,或去看现场音乐演出与节庆。
bill001g 或许他可以多看些 Linus Tech Tips 的视频找找灵感。看起来像是个新人,频道才成立一年,却装作这是一件前所未见的事。回复
本文来源:https://www.tomshardware.com/pc-components/liquid-cooling/trashbench-repurposes-a-trash-4-kw-air-conditioner-radiator-for-his-test-bench-to-see-how-well-it-can-cool-a-pc-achieves-a-shocking-28c-on-an-nvidia-rtx-3080
若有版权问题,请来信告知:13951431913#139.com 或在右方提交评论。
This is giving me some seriously questionable ideas...
When you purchase through links on our site, we may earn an affiliate commission. Here’s how it works .
Just like we suspected, our fellow Australian hardware examiner TrashBench is up to shenanigans again. Not too long ago, after putting a graphics card in the "wrong" place for much better cooling results, he's ... thinking bigger, let's put it that way. He took an old 4-kW outdoor radiator-fan unit from a split air-conditioning setup (sans gas) and hooked it up to a water-cooling loop to assess its performance.
He kicked off the video with his best impression of Crocodile Dundee , and set out to rearrange the unit for the task at hand, as he only needed the actual radiator, fan, and pump. Most of the fiddly guts were taken out, and casters were added for convenience. TrashBench then added a bog-standard reservoir to the main enclosure.
Moving on to the PC side, he converted a T-joint into a Y-joint with judicious application of heat and force, and, being the ever-clever craftsman, designed 3D-printed mounting brackets for the various cold plates. It was around this time that it was made certain he'd be successful, as at 02:49 you can see that his knuckles paid the requisite blood toll to the machine god.
After firing up the entire system, he set to benchmarking , enlisting both a modern RTX 5060 and a hotter, earlier RTX 3080 for the process. The 5060 is a very power-efficient GPU, and its temperature with the standard cooler was a tame 52ºC. However, the mighty power of four kilowatts' worth of cooling brought that down to just 33ºC, around the temperature of lukewarm water, and a 16ºC drop altogether.
With such a wide thermal range to work with, he set out to overclock the living daylights out of the GPU, moving the boost clock needle from 2902 MHz up to 3300 MHz. Despite the 14% clock-speed improvement, average FPS saw a mere 3% uplift, clearly highlighting how perfectly Nvidia has the power/performance curve dialed in since the RTX 2000 series.
Crazed modder straps 360mm AIO radiator to laptop, cuts temps to below 40 degrees
Modder discovers that putting a GPU in the 'wrong place' can deliver a 19 degree cooler hotspot

Enthusiast mods GTX 1080 Ti with a dual-tower CPU cooler, sees up to 32°C reduction in temps
He then moved on to the RTX 3080, a beastly, much more power-hungry card that could provide a worthy challenger for the Fujitsu radiator. It was promptly defeated, and its temperature went from 65ºC down to just 28ºC, or in other words, not much above ambient. Overclocking this card, however, also yielded a mere 3% fps, barely worth the man's time.
The final challenge was seeing how well the teeny weeny Fujitsu could handle a combined GPU and CPU load. The processor on hand was probably the worst possible consumer chip to try and keep cool, the lightning-fast and flame-hot Intel Core i9 14900K.
Get Tom's Hardware's best news and in-depth reviews, straight to your inbox.
TrashBench hooked it up and saw CPU temperatures drop 18ºC down to 76ºC, a strong achievement for this silicon outside of rooms with liquid nitrogen buckets. As for the graphics card, its heat sensor simply didn't move at all, suggesting that the radiator had far greater headroom than TrashBench had hardware.
Follow Tom's Hardware on Google News , or add us as a preferred source , to get our latest news, analysis, & reviews in your feeds.
Bruno Ferreira is a contributing writer for Tom's Hardware. He has decades of experience with PC hardware and assorted sundries, alongside a career as a developer. He's obsessed with detail and has a tendency to ramble on the topics he loves. When not doing that, he's usually playing games, or at live music shows and festivals.
bill001g Maybe he can go watch some more linus tech tips videos for inspiration. Seems like a new guy,channel is only a year old, pretending this is something that has not been done before. Reply