10 欧元自制手柄:RP2040 加 GP2040-CE 固件The 10 Gamepad


AI free token/AI免费积分
10 欧元自制手柄:RP2040 加 GP2040-CE 固件

我们不确定 Lazy_Duck 拿手柄做什么,但看起来他需要大量控制器。面对商业手柄的价格与复杂度,他干脆拿起烙铁和 3D 打印机,做了一个更便宜的基础控制器。

项目的重点在于「随手拼起来」,因此没有专用 PCB,只有一块洞洞板,上面是 RP2040-Zero、一个摇杆、几个按键和一个微动开关,再配上一个 3D 打印外壳。打印部分使用了热熔铜螺母,结构相当结实。软件方面由 GP2040-CE 固件接管一切,把手柄功能全部搞定,并通过网页进行配置。

即便你不想要便宜手柄,这里的思路和软件也可以用来做任何你想要的手柄。该固件很好地利用了 RP2040 的双核,还可以加入 OLED 显示屏、RGB 灯等更多内容。当然,3D 打印也可以玩得更花,比如用光固化打印机做出漂亮的键帽。

本文来源:https://hackaday.com/2026/10/16/the-10e-gamepad/
若有版权问题,请来信告知:13951431913#139.com 或在右方提交评论。

We aren't sure what Lazy_Duck is doing with video games, but it must require a lot of controllers. Dismayed at the cost and complexity of commercial gamepads, they started soldering and 3D printing to get a cheaper basic controller.

The emphasis is on throwing things together, so there's no dedicated PCB. Just a protoboard with an RP2040-Zero, a joystick, a few buttons, and a microswitch. A 3D-printed case rounds out the project.

The 10 Gamepad

On the printing side, the device uses heat-set threaded inserts, which should make for a very sturdy build. For software, the GP2040-CE firmware handles everything, acting like a controller and managing configuration via a web page.

Even if you don't want a cheap gamepad, you could apply the principles and software used here to create any kind of gamepad you want. The firmware makes good use of the dual-core RP2040. It also offers a lot you could add to your version of the cheap controller, like OLED displays, RGB LEDs, and more. Of course, you could also get fancy with the 3D printing side, too. For example, a resin printer makes nice button caps.

暂无评论,快来发表第一条评论吧!No comments yet. Be the first!

📮 需求咨询📮 Inquiry