
1993 年 id Software 发布《DOOM》,定义了整个游戏类型,但那个十年的第一人称射击佳作并非只有它——3D Realms 1996 年的《毁灭公爵 3D》(Duke Nukem 3D)为这一类型注入了别样的幽默。如今,[PicoPlus-devel] 带来了 pico-duke3D:在 RP2350 上运行的《毁灭公爵 3D》。
在得出"这显然很容易"的结论之前,不妨看看两款游戏发售间隔的三年间 PC 硬件发生了多大变化:《DOOM》1993 年的最低配置是 386 加 4MB 内存,一块基础 VGA 卡加 ISA 插槽即可畅玩;而三年后的《毁灭公爵 3D》至少需要 486DX2 和 8MB 内存,还少不了 VESA 局部总线或 PCI 显卡。它对标的是《Quake》而非《DOOM》,所需的算力自然上了好几个台阶。
而 RP2350 扛住了这个任务:游戏运行在一块带 DVI 输出的 Pico 兼容板上,配上相应硬件可通过 SNES 或 USB 手柄控制,是完美的"单人游戏机"。共享版游戏可以直接运行,拥有正式版的玩家同样可以玩。作为看着这些游戏长大的一代人,我们不禁好奇:《影子武士》(Shadow Warrior)是不是也有希望跑起来?你休想惹 Lo Wang!
本文来源:https://hackaday.com/2026/10/13/does-it-run-duke-nukem-3d/
若有版权问题,请来信告知:13951431913#139.com 或在右方提交评论。
When id Software released DOOM back in 1993 it helped define the genre, but it was hardly the only hit first-person shooter of that decade. There was also 3D Realms' 1996 Duke Nukem 3D, a game which added some humor to the genre. Here's PicoPlus-devel, with pico-duke3D. It's Duke Nukem 3D, on an RP2350.
Before reaching the conclusion that this might be obvious and easy, the three years between the two releases saw quite significant movements in the world of gaming PCs. DOOM's minimum spec in 1993 was a 386 and 4 MB of memory, and would have been playable on a basic VGA card in an ISA slot. By contrast three years later, Duke Nukem 3D required at least a 486DX2 and 8 MB, which would inevitably have had VESA local bus or PCI graphics. It's a Quake competitor rather than a DOOM competitor, thus the power required to run it has stepped up a notch or two.

The RP2350 then is up to the job, and runs the game on a DVI equipped Pico clone. It can be controlled via either SNES or USB controllers given the right hardware, making it the perfect one-game console. The shareware game works, as does the full version if you own a copy. Having been around in the '90s then, we're curious. Could it be made to run Shadow Warrior as well? You no mess with Lo Wang!